Our service promise

We aim to provide not only top quality products but also the highest standards in sales and after sales service.

Our Australian & New Zealand team of Area Sales Managers are dedicated to assist and support both Super Ego brand stockists and distributors and their trade and industrial customers with technical advice and an ongoing schedule of demonstration activities Australia and New Zealand wide.

The Super Torch Plus offered by Super Ego is a 5-in-1 device. There are five different burner inserts available for numerous applications:  the fine point burner offers a precise, fine soldering flame for soft soldering work.  The standard burner offers a powerful, stable flame and is primarily recommended for soft soldering work and work with a low heat supply. With 950°C the cyclone burner offers the highest operating temperature and can be used both for hard soldering (up a 28 mm pipe diameter) as well as for soft soldering. Using its swirl flame, the flame wraps itself around the pipe and allows even rapid heating of the soldering point. The hot air burner is specially used for smaller shrinking work up to 80 mm in diameter or to remove paint. Since it does not have an open flame, the hot air stream is particularly stable in the wind. For larger shrinking work (up to 300 mm) and for heating, the shrink burner offers a powerful soft flame which is stable in the wind.

Yes, due to the special burner construction the Super Torch Plus is very suitable for overhead work when operating with the MAP/Pro Gas cartridges.

Seals are parts subject to wear. Ensure before every use of the Super Torch Plus whether the seal is placed correctly and is in good condition. The sealing ring is located behind the threads in which you screw in the gas cartridge. If the sealing rings are, for example, brittle, cracked or strongly deformed or even missing, definitely replace them! New seals can be obtained in packs of two from your specialist dealer using the article number 830806.

The operating temperature depends on which of the 5 burner inserts are used: Fine point burner 460°C Standard burner 700°C Cyclone burner 950°C Hot air burner 400°C Shrink burner 720°C

The piezo-ignition can be actuated up to 30,000 times.